The A/C250 accumulation conveyor incorporates chain driven urethane traction wheels with molded Delrin sprocket to drive carrying rollers. It offers true zero-pressure accumulation and versatility – controlled discharge zones, optional release modes, and dual sensor arrangements.

Features
True zero-pressure accumulation.
No fine tuning required.
3” carrying roller spacing.
30” long accumulation zones.
Pre-engineered and assembled.
Low maintenance.
Self adjusting elements.
Powder coat finish.
Optional power take-off (pto) to slave drive t/c250 curves and junctions.
Optional light load sensors.


Specifications and Data
Frame – 5-1/2” x 1-1/4” x 10 gauge formed steel channel. Powder coat grey finish.
Carrying Rollers – 1.9” diameter x 16 gauge, galvanized rollers on 3” centers.
Sensor Rollers – Aluminum rollers with grease packed bearings, pivotally mounted at 30” centers.
Clutch – Precision molded sprocket and urethane tread mounted on channel frame, four in each accumulation zone.
Drive Chain – No. 40 roller chain.
Bed Widths – 16”, 22”, 28”, 34”, and 40” between frames.
Bed Lengths – Available from 12’-0” minimum to 150’-0” maximum in 30” increments.
Capacity – 100 pounds per foot.
Drive – End type located at discharge end of conveyor with automatic chain tensioner. Sprocket keyed to 1-7/16” diameter
Steel shaft mounted in grease packed-for-life bearings.
Take-Up – Manually adjustable screw type at infeed end.
Power Unit – From 1/3 to 3 HP TEFC, C-FACE motor/reducer units. Side mounted units available for low elevation.
Speeds – 45, 60, 75, 90, 120, 150, and 180 feet per minute.
Power Take-Off Units – Chain drive components (1:1 speed ratio) and end terminal connection to adjoining “upstream” powered belt, A/C, and T/C conveyors.
Operating Air Pressure – 5-10 PSI. An air filter/regulator is furnished with each conveyor.
Operational Release Modes – Singulation, Slug, and Auto-Slug.
Unit of Measure