Frame – 9" x 7 gauge powder painted formed steel channel frames. Sections are bolted together with splice plates and floor supports.
Chain – (2) 60F single pitch conveyor chains, straight side bar, on 36" centers.
Chain guide – UHMW.
Floor supports – 24" to top of chain. One support supplied at each end of conveyor and at each bed joint.
Motor – Motor and speed reducer are located underneath conveyor frame.
Speed reducer – Heavy duty worm gear for C-face mounted motor.
Sprockets – Hardened sprockets with 1 15/16" diameter CRS drive shaft.
Bearings – Sealed, pre-lubricated with cast iron housing.
Capacity – Maximum motor size is 3 HP. Not to exceed Load capacity.
Unit of Measure
|N/A 1 hp 230/460-3-60 TE motor, C-face|
|N/A 30 fpm|
|N/A 10000 lb|