• Oily conditions
  • Pallets
  • Drums
  • Positive drive

  • Bed – 2 1/2" diameter x 11 gauge and 2 5/8" x 7 gauge steel tread rollers, 11/16" hex shafts. No. 50 chain is used on 5", 7 1/2", 10" roller centers only. No. 60 chain is used on 6", 7 1/2", and 12" centers only. Tread rollers mounted in 4" and 6" x 4 gauge powder painted formed steel channel frame. Sections are bolted together with butt couplings and floor supports.
    Drive chain – No. 50 roller chain or No. 60 roller chain can be used with either the 251CRR or 267CRR as above.
    Floor supports – Heavy duty supports are adjustable 30 1/4" to 40" from floor to top of roller. One support at every bed joint and each end of conveyor.
    Center drive – Mounted underneath conveyor, center of section. Can be placed most anywhere in conveyor length.
    Bearings – Sealed, prelubricated ball bearings.
    Chain guard – Lower chain guard is mounted on bottom of roller frame, and upper chain guard is mounted above roller frame to totally enclose drive chain.
    Speed reducer – C-face mounted heavy duty worm gear reducer.
    Capacity – Maximum load per linear foot of conveyor; 300 lbs. with supports on 10' centers, 1000 lbs. with supports on 5' 0" centers.

    Available Options
    - Side Mounted Drive: Motor/Reducer unit can be mounted to side of conveyor frame for lower elevations. Drive is higher than conveyor frame.
    - Conveyor Speed: 30 feet per minute is standard. Other constant, and variable, speeds are available.
    - Rollers Set Low: Rollers can be set low in conveyor frame to provide a guard rail effect.
    Unit of Measure

    Drive Chain Type

    N/A 251 CRR

    Conveyor Length

    N/A 15 ft

    Conveying Surface Width

    N/A 28 in

    Width between Frames

    N/A 31 in

    Overall Width

    N/A 34 in
    Weight1 N/A 964 lb

    Standard Color

    N/A ACSI Green ACSI Gray ACSI White ACSI Dark Blue ACSI Tan ACSI Black


    N/A 3/4 hp 230/460-3-60 TE motor

    Speed Constant

    N/A 30 fpm
    • 1 Based on 5" Roller Centers