• Heavy duty conveying
  • Positive drive
  • Pallets
  • Heavy drums
  • Reversible drums


  • Bed – 6" x 8.2 lb. and 8" x 11.5 lb. powder painted structural channel frame with powder painted structural channel cross braces in each section. Sections are 5 feet long and bolted together with butt couplings and floor supports.
    Tread rollers – 3 1/2" diameter x .30 wall steel tread rollers spaced on 6" or 12" centers, No. 80 sprockets, 1 1/16" hex shaft.
    Drive chain – No. 80 roller chain.
    Floor supports – Heavy duty structural supports are fixed at 18" elevation from floor to top of roller. One support at each end of conveyor and at each bed joint.
    Center drive – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.
    Bearings – Removable, sealed, prelubricated ball bearings.
    Chain guard – Lower chain guard is mounted on bottom of roller frame, and upper chain guard is mounted above roller frame to totally enclose drive chain.
    Speed reducer – C-face mounted heavy duty worm gear reducer.
    Capacity – Not to exceed Load capacity.

    Available Options
    - Side Mounted Drive: Motor/Reducer unit can be mounted to side of conveyor frame for lower elevations. Drive is higher than conveyor frame.
    - Conveyor Speed: 30 feet per minute is standard. Other constant, and variable, speeds are available.
    - Rollers Set Low: Rollers can be set low in conveyor frame to provide a guard rail effect.
    Unit of Measure

    Conveyor Length

    N/A 5 ft

    Conveying Surface Width

    N/A 19 in

    Width between Rail

    N/A 23 in

    Overall Frame Width

    N/A 27 in
    Weight1 N/A 792 lb

    Motor

    N/A 2 hp 230/460-3-60 TE motor

    Speed Constant

    N/A 30 fpm

    Capacity per Foot Max.

    N/A 2000 lb
    • 1 Based on 6" Roller Centers